Myth 1: It's more energy-saving to use it immediately. Wrong! The heating material of electric heating is buried in cement or under the floor. After opening the system, it takes a certain time to reach the set temperature. When closing the system, the indoor temperature will also take a long time to fall. Frequent switch not only can not save energy, but also can increase operating costs and reduce the service life of electric heating.
Correct Practice: You can set the temperature of the uncommon room a little lower, and the common room only needs to adjust the temperature when it leaves for a long time.
Myth 2: Some people think that turning on the system when it is very cold can shorten the use time, so as to achieve the goal of energy saving. In fact, because of the low room temperature, the system needs a long time to work to reach the set temperature, which greatly increases energy consumption.
Correct practice: It is suggested that the system be opened at room temperature of 12 C, and the room temperature should be set to 14 C. When the room temperature is constant at 14 C, then the temperature is raised to 16 - 18 C.
Myth 3: Set the temperature higher and the temperature will rise faster. Wrong! The heating time depends on many factors, such as temperature difference between indoor and outdoor, installation power per unit area, thermal insulation of houses, etc. When the temperature difference between indoor and outdoor and the installation power are fixed, the heating time of setting the temperature to 18 is the same as that of 25.
Correct practices: the optimal temperature of electric heating is 18 - 20 C, each increase of 1 C will increase energy consumption by about 10%, and each decrease of 1 C will reduce energy consumption by about 5%. Electric heating at 18 C is equivalent to centralized heating at 20 C. Users can flexibly adjust the temperature of day and night, at home, leaving and so on by using the temperature controller according to the actual situation.
Power saving skills
Houses should be well insulated
Doors and windows can not have obvious cracks, windows with double-layer hollow glass, wall insulation, energy-saving effect is very significant.
Reasonable power allocation
In fact, too small power allocation wastes more energy. The power allocation is too small, and the floor heating is always working to reach the set temperature, but it can not always reach the set temperature. This is because the floor heating fills the room with less heat than the loss of heat, the room temperature is not obvious, not only waste electricity, but also can not achieve comfortable heating effect.
Reasonable selection of temperature controller
The thermostat can automatically raise or lower the indoor temperature by preset. A good thermostat has high sensitivity to temperature. It can stop heating immediately when it reaches the set temperature and start heating immediately when the indoor temperature is lower than the set temperature.
Rational Utilization of Peak and Valley Electricity
Using night Valley electricity, the temperature is slightly raised, the ground heating energy can store heat at night, the peak electricity during the day, and then lower the temperature, the heat storage at night can be released, and the power consumption will naturally be low. If the room has good thermal insulation performance, it can even save electricity during the day.
All right, so much said, in order to enable everyone to have a better life and a more comfortable home. If the economy permits, quickly warm up the comfortable electricity to go home!